Plastiprimer Ultra White Post-Cat Pigmented Primer 1 gal. (can)

Mix well before and during the addition of catalyst and diluents. To assure consistency, always keep the product under agitation. The Plastiprimer can be applied in one or two layers. A good sanding between coats with paper 240/320 is needed to get a good adhesion. The Plastiprimer must be covered within 8 hours after the sanding. When sanding, it is important not to wear through the surface and to pay particular attention to sharp edges of the profile. This can create a non-uniform thickness of the application. Once catalyzed, avoid all contact with metallic surface. The dry film thickness of the Plastiprimer must not exceed 3 mils. The total dry film thickness of the system should not exceed 5 mils.

To obtain a complete cure, the system should be applied at an ambient temperature above 18°C and a relative humidity below 65%. During curing, this product should not be exposed to ammonia vapors. The finished surface cannot be cleaned with an ammonia-based product. Always use containers and equipment in plastic or stainless steel to eliminate any source of discoloration due to oxidation.

Topcoats to use over 220-005: 117-30XX, 117-32XX, 440-0XX and 484-6XXX.