Danspeed® Extra Light Post-Cat Clear Topcoat Satin Gloss 5 gal. (pail)
Danspeed Extra Light is a two component, high solids reactive amino coating. It provides a smooth, hard wearing surface that is resistant to alcohol, water, grease and usual household chemicals. Danspeed Extra Light has improved yellowing resistance when compared to Danspeed Extra.
Agitate material before use. Always mix Danspeed Extra Light while adding hardener and reducers in the recommended mixing ratios. Danspeed Extra Light must be agitated thoroughly at all times to ensure product consistency and consistent gloss.
Apply at 3-5 mils wet on sanded substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper.
Contact with metal surfaces should be avoided.
Maximum film build of Danspeed Extra Light should not exceed 4 mils dry. Maximum film build of total coating system must not exceed 4 mils dry.
To obtain a complete cure, the system should be applied at an ambient temperature above 18ºC and a relative humidity below 65%. When drying, this product is not to be exposed to ammonia vapors. Finished surfaces must not be cleaned with ammonia containing products.
482-3XX can be used as a self-seal or with following sealers: 390-001, 390-0060, 401-004 catalyzed, 401-028 catalyzed, 432-1220, 546-5192 and 546-8003.
| Net Weight (kg) | 1 |
|---|---|
| UPC EAN Car | N/A |
| UPC EAN PC | N/A |
| Gross Weight Carton (kg) | 1 |
| Units Per Carton | 1 |
| Volume (L) | N/A |
| Brand | Chemcraft |
| Is Made to Order | No |