Danspeed® White Post-Cat Pigmented Topcoat Low Gloss 5 gal. (pail)
Danspeed White is a pigmented post-catalyzed Reactive Amino Coating (RAC) with very good light stability based on the choice of resin used in the product. Danspeed White gives a smooth, knock proof and hard-wearing surface resisting influence from alcohol, water, etc
Special recognition: when applied as specified, will meet required performance for the ANSI/KCMA A161.1 1990 9.0 Finish Test.
Catalyze and reduce the material as recommended. To ensure proper sheen, the catalyzed material should be agitated at all times. Danspeed White must be thoroughly stirred while adding catalyst and thinner in the recommended mixing ratio. Apply 3-5 mils wet on sanded surface. A subsequent coat can be applied after complete cure and a good sanding with a #280/320 grit paper is necessary to obtain a good adhesion. Eliminate all contact with metallic surfaces. Dry film thickness of topcoat must not exceed 3 mils. Total dry film thickness of system should not exceed 5 mils. Danspeed White cannot be used on metal, old oil or cellulose lacquers. Contact with metal surfaces should be avoided once it has been catalyzed. Danspeed White must not be polluted with oil, varnish or the like and must not be sanded with steel wool between coats
To obtain complete cure, the primer must be applied at a temperature above 18ºC and relative humidity below 65%. When drying, this product is not to be exposed to ammonia vapors. Finished surface must not be cleaned with ammonia containing products.
Primers to use with 484-6XXX: 220-005, 220-214, 220-2250, 225-0010, 522-1624, 545-8016 and 546-7257.
| Net Weight (kg) | 1 |
|---|---|
| UPC EAN Car | N/A |
| UPC EAN PC | N/A |
| Gross Weight Carton (kg) | 1 |
| Units Per Carton | 1 |
| Volume (L) | N/A |
| Brand | Chemcraft |
| Is Made to Order | No |