Aqualux Uniclear WB Clear TC Matte , 1 gal. (can) – 423-4610-D1CP

Mix material before use. Add water to reduce, if required, and mix thoroughly. Apply by spray at wet film builds of 4 - 5 mils. Application and drying conditions must be at temperatures of 64°F or above and at a humidity of less than 65%. Increased airflow and/or drying temperatures, including the use of infrared, will greatly decrease dry times.Apply at 4 - 5 mils wet on sanded or sealed substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper. Second and subsequent coats must be applied the same day the previous coat is sanded.Aqualux Uniclear must be agitated thoroughly at all times to ensure product consistency. Contact with metal surfaces should be avoided. In the curing cycle, the addition of heat and air movement will shorten the drying time.Note: Aqualux Uniclear must not be polluted with oil, solvent based paint or the like and should not be applied to metal surfaces. Aqualux Uniclear must not be sanded with steel wool between the coats. This coating must not be used and dried at temperatures below 64°F or relative humidity above 65%.Film build should not exceed 2 dry mils per coat. Total film build must not exceed 4 dry mils.