Plastiprimer Neutral Post-Cat Primer, 5 gal. (pail) – 522-1350-D5PRF

Mix Plastiprimer Neutralthoroughly, then catalyze and reduce material as recommended. Plastiprimer must be well mixed while adding hardeners and reducers and must be agitated at all times to ensure product consistency.Plastiprimer Neutralis applied in one to two coats and can be used as a primer for most wood and wood products meant for indoor use. A thorough sanding using 240/320 grit stearated paper between coats is essential for adhesion. The second and subsequent coats must be applied the same day as the previous coat is sanded. Care should be taken to avoid sanding through the primer coat. With profiled edges, care must be taken with sanding of primer to avoid sanding through sharp edges. Complex profiles or profiles with sharp corners may cause difficulties in obtaining an effective primer coat of even thickness. In these cases, profile design must be discussed with your technical representative. Contact with metal surfaces should be avoided once the Plastiprimer has been catalyzed. To ensure proper uniformity, the material should be agitated at all times. Recommended film build of Plastiprimer is not to exceed 4 mils dry. Total recommended film build of Plastiprimer and topcoat is not to exceed 6 mils dry.Plastiprimer Neutralmust not be polluted with oil, varnish or the like and must not be sanded with steel wool between the coats. Plastiprimer must not be used and dried at temperatures below 64°F or relative humidity above 65%. During the curing process, the coating must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finish surfaces. This may accelerate discoloration.