Plastofix Light Post-Cat Clear TC Satin, 5 gal. (pail) – 421-4835-D5PRS

Catalyze and reduce the material as recommended. Plastofix Light is applied in one to three coats on all kinds of wood meant for indoor use. On open pored woods, the best self-sealing is obtained by adding a minimum of 25% Reducer 803-1325 to the Plastofix Light after catalyzing. Thorough sanding between the coats is a must for good adhesion. The second and subsequent coats must be applied the same day as the previous coat is sanded.Contact with metal surfaces should be avoided once the Plastofix Light has been catalyzed. To ensure proper sheen, the catalyzed material should be agitated at all times.This product can be used as a self-sealer if reduced 20 30%. Appropriate sealers are Catalyzed Vinyl Sealer 546-7023 with 3% Catalyst 873-0870, or Chemvinyl 546-8002, or Danseal 432-1220. Consult with your coatings supplier for specific recommendations.Plastofix Light demonstrates excellent resistance to marring, dry heat, moisture, household and office liquids, etc. When this product is used as its own sealer, its special formulation ensures excellent filling and easy sanding properties with superior holdout for subsequent coating. Plastofix Light must be thoroughly stirred, while adding catalyst and reducer in the recommended ratio. Total recommended film build of Plastofix Light and sealer should not exceed 4 mils dry.Plastofix Light must not be polluted with oil, varnish or the like and must not be sanded with steel wool between coats. Plastofix Light must not be used and dried at temperatures below 64°F or relative humidity above 65%. During the curing process, the coating must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finished surface. This may accelerate discoloration.