E-Var 550 Post-Cat Clear TC Satin 1 gal. (can) – 421-8240-D1CG

Agitate material before use. E-Var 550 must be agitated thoroughly at all times to ensure product consistency and consistent gloss. Always mix E-Var 550 while adding hardener and reducers in the recommended mixing ratios. Apply at 3-5 mils wet on sanded substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper. The second and subsequent coats must be applied the same day as the previous coat is sanded.Maximum film build of E-Var 550 should not exceed 4 mils dry. Maximum film build of total coating system must not exceed 4 mils dry. Contact with metal surfaces should be avoided.E-Var 550 must not be polluted with oil, varnish or the like and must not be sanded with steel wool between the coats. E-Var 550 must not be used and dried at temperatures below 64°F or relative humidity above 65%. During hardening the coating must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finished surface. This may accelerate discoloration.Please note that, as with any other amino-containing product, this material contains, and has the potential to emit, formaldehyde (CAS# 50-00-0). As per the US Department of Labor Standard 29 CFR 1910.1048 covering formaldehyde, section (d)(1)(i) states that Please refer to the OSHA web site at for further information..